|
Small Linear Scanner
System
OPSLSS
|
| |
| |
| |
This scanner can be made in different versions, and adapted to the needs
of the customer. Two versions was already made: one uses elastic
membrane and focused transducer and is intended for spot weld
measurement, the second one has much smaller diameter and was made for
soft palate measurements.
|
The system contains following elements:
- Pulser&Receiver (OPGUD);
- UT-card (OPKUD01/100);
- Linear Scanner
- Software package.
|

|
| Technical
data |
|
A/D converter: |
|
- Resolution: |
8
bit |
|
- Sampling frequency: |
50
or 100MHz 1 |
| Analog
parameters: |
|
- Input channels: |
2
(switched): send & receive and receive |
|
- Input amplifier gain: |
0dB,
6dB, 14dB, 20dB, 26dB, 34dB, 40dB (hardware amplifier on the card)1 additional
33dB in echo mode (amplifier in the pulser & receiver box)total
possible gain: 110dB (with software amplification) |
|
- Input attenuator |
10dB1 |
|
- Minimal sensitivity: |
0.1mV/Div
-1mVpp (with software amplification) |
|
- Maximal sensitivity: |
50mV/Div
- 0.5Vpp |
| Averaging |
1
- 256 |
| Bandwidth: |
0,1
- 25MHz |
| Input
impedance: |
50Ohm,
10pF |
| Trigger: |
internal
(software), external, max 2 kHz |
| Delay
time: |
Post
trigger 256us, measurement accuracy better than 1ns |
| Pulser: |
Step
pulser, 50V -300V in 8 levels (the voltage depends on the used transducer),
20ns edge falling time, separate, match box size |
| Data
buffer: |
256,
512, 1K or 16K1 |
| Software
Package: |
The software allows to make A and B scans with or without RF
visualization, allows to use different filters etc. Optional it is
possible to make software versions for the special needs of the user.
|

|
|